Job: Carpenter
Reports to: Sheet Metal Supervisor
Job Summary
The Carpenter fabricates, assembles, fits, and installs structural and light-gauge steel components used in prefabricated modular mechanical and electrical systems. This position works with structural steel, metal framing, metal studs, angle iron, channel, tubing, Unistrut, and related materials.
The Carpenter reads drawings, performs accurate layouts and measurements, operates fabrication equipment, and produces completed assemblies that meet project specifications, quality standards, and production schedules.
This is a fully on-site position. The employee will complete a minimum 90-day on-site training period at Epsilon Industries’ Tuscaloosa, Alabama facility and will receive a per diem of $500 per week during the training period. Upon completion of training, the position will transfer to and remain fully on-site at Epsilon Industries’ Oxford, Alabama facility.
Job Duties & Responsibilities:
Fabrication & Assembly
Fabricate and assemble steel and metal components for modular mechanical and electrical systems.
Work with structural steel, light-gauge steel, metal studs, angle iron, channel, tubing, Unistrut, and related products.
Measure, lay out, cut, drill, grind, fit, square, level, and assemble components accurately.
Construct frames, supports, platforms, racks, enclosures, and other modular assemblies.
Perform basic fitting and preparation of steel components before welding or final assembly.
Perform tack welding when properly trained, qualified, and authorized.
Assist with installing completed components within modular units and other assemblies.
Follow established fabrication sequences, procedures, and production requirements.
Drawings & Quality
Read and interpret shop drawings, fabrication drawings, blueprints, dimensions, and material requirements.
Verify measurements, layouts, dimensions, tolerances, squareness, level, and alignment.
Confirm that materials and completed assemblies match approved drawings and specifications.
Identify dimensional, material, drawing, or fabrication concerns before work proceeds.
Report defects, discrepancies, and unclear requirements to the supervisor.
Inspect completed work and correct deficiencies within assigned authority.
Maintain consistent workmanship and quality standards.
Support continuous improvement and reduction of material waste and rework.
Tools & Equipment
Safely operate hand tools, power tools, saws, drills, drill presses, grinders, and other fabrication equipment.
Inspect tools and equipment before use.
Use tape measures, squares, levels, and other measuring devices accurately.
Select the proper tools, materials, and equipment for assigned tasks.
Report damaged tools, equipment malfunctions, and maintenance concerns promptly.
Maintain tools and equipment in a clean and serviceable condition.
Production & Teamwork
Coordinate work with Welders, Sheet Metal personnel, Production employees, Quality, and supervision.
Complete assignments according to established production schedules and priorities.
Communicate material, drawing, tooling, quality, or production issues promptly.
Assist with positioning, staging, and handling steel and fabricated components.
Maintain accurate identification of parts and project materials.
Work independently while supporting team and departmental objectives.
Assist with training less-experienced employees when requested.
Safety & Housekeeping
Follow all company safety policies, procedures, and personal protective equipment requirements.
Use proper lifting, material-handling, and equipment-operating techniques.
Secure materials and workpieces before cutting, drilling, grinding, or assembly.
Maintain awareness of sharp edges, hot work, pinch points, moving equipment, and other shop hazards.
Keep work areas clean, organized, and free of unnecessary hazards.
Participate in required safety meetings, toolbox talks, and training.
Stop work and notify supervision when an unsafe condition is…